Everyone must be familiar with the Lenovo brand. When mentioning the Lenovo brand, everyone will definitely think of Lenovo computers. Yes, Lenovo computers have very good reviews. The computer I will introduce to you today is called Lenovo g510. This computer is a very nice looking computer. Today, the editor will introduce to you some methods of using or setting up this computer. So that when using the computer, there is nothing that you do not know how to set up. Everyone should listen carefully.
One: Lenovo g510 quotation.
1: The price of Lenovo g510 is 4,500 yuan/unit (the price comes from the website and is for reference only).
2: How to disassemble the Lenovo G510 and add memory?
1: The D side (bottom side) of the Lenovo G510 is a whole , need to be completely removed before adding a memory module.
How to disassemble the phone and add memory: 1. Remove the battery and see two screw holes; 2. Unscrew the screws and draw out the entire D surface to remove it; 3. Find the space. Insert the memory stick into the bottom of the memory slot at a 45-degree angle, and then press it down flat. When you hear a "click", it means it is installed. 4. Power-on detection. If the computer's memory shows the added memory size, it means it has been installed. Right-click "Computer" and click "Properties" to view it. For example, my computer has original 4G memory. If I add 4G, it will show 8G here, which means the installation is correct.
Three: How to clean the Lenovo g510 computer.
1: Use a Phillips screwdriver to remove the screws behind the radiator module on the back of the notebook (it is recommended that you get a box to put the screws in to avoid losing the screws).
2: Open the notesBehind the shell of this CPU radiator module, we can see the following internal structure.
3: After removing all the radiator and fan screws, we first carefully pull out the 4PIN power supply connector of the cooling fan.
4: Next, we need to clean the fan. Some fan blades can be removed, so we can directly flush them with water. If the fan cannot be removed, then we can only wipe it slowly. Don’t touch the water!
5: After the above operations are completed, we can reinstall the cleaned and dried heat sink and heat pipe. Don’t rush to install the screws first. Press the heat dissipation fins on the chip to see if there is good contact. After good contact, install the fixing screws. Note that the fixing screws here must not be too tight to avoid damaging the motherboard, but they must not be too loose to affect heat dissipation. Instead, they should It's enough when it can't be twisted with a little force.
Four: Lenovo G510 enters bios.
1: Restart the computer. When the Lenovo logo appears, immediately press Fn + F2 to enter the BIOS setup interface. If the Lenovo logo does not appear when restarting the computer, it means that fast startup has been activated, and you cannot enter the BIOS setup interface by pressing Fn + F2 when booting. In this case, please shut down the computer first, then press the one-key system rescue button and select "Enter Setup" to enter the BIOS setup interface.
2. In the BIOS setting interface, enter the "Configuration" menu, change the "Hotkey Switch" setting from "Hotkey mode" to "Legacy Mode", then press F10 to save and exit.
The above is the Lenovo g510 computer introduced by the editor. Everyone introduced the price of this computer. If you are interested in this computer, you can refer to this price. In addition, the editor also introduced you how to disassemble the computer and use the memory, how to enter the bios, and how to clean the computer after using it. Everyone knows that computers are very easy to get dirty, so we need to clean them every once in a while to facilitate the operation of the computer. I hope my introduction can help you.